THA 315 THA 465
INSTALLING THE TOWEL RAIL:
Electrical installation:
This product is only to be used attached to the wall.
NOTE: To avoid any hazard to children, the towel rail must be installed so the bottom bar is at
least 600 mm above the ground.
Fixing the towel rail to the wall:
NOTE: If you have any doubts about installing the towel rail, please contact a professional.
Leave minimum safety distances between the towel rail and the other fixtures in your bathroom.
You must leave at least 8 cm between the rail and the wall, and 20 cm around it.
The mounting of the towel rail on the wall must be done using the three anchor points located at the
ends of the appliance (two between the upper tubes 2 and 3; and one in the middle between the lower
tubes 2 and 3).
1. Using a pen or pencil, mark the three mounting points on the wall coinciding with the
towel rail mounting points.
2. Drill the holes in the wall, insert the wall plug, and then install the anchor tubes (2) fixing
them to the wall using the screws (3).
3. Insert support 4 in tube 2 and fix it with screw 1.
4. Place the towel rail on the wall and attach it to the wall support with plastic piece 5 and
its screw 6.
5. Finish the installation by placing trims 7.
Always make sure that the towel rail has been securely attached.
28