Connection And Set Up; Cable Installation - Engel andriodtv LE 5090 ATV Manual De Usuario

CONNECTION AND SET UP

CABLE INSTALLATION

Carefully read the relevant content in "Maintenance and Safety Notice" before installation and use.
1. Remove the TV from the retail box and place it on a secure flat surface.
NOTE:
When plugging or unplugging the TV, computer, or other equipment, you need to make sure that
the AC power has already been turned off; When unplugging the power cord or signal cable, hold
the plug (the insulated part), do not pull on the cable body.
2. The RF output terminal can be connected to the RF input port on the TV.
3. The DVD output AV terminal can be connected to the TV's AV input port through the AV cable.
4. Connect one end of the HDMI cable to the HDMI output port, connect the other end of the HDMI
cable to the HDMI port on the TV. It supports HDCP 2.2 on all HDMI inputs.
NOTE:
When connecting the HDMI, please insert carefully, do not press too hard so that the pin does not
break.
5. Check and make sure that all AV cables are properly connected with the corresponding ports.
6. Connect the AV power cable to a 100-240 VAC power supply.
NOTE:
The power input range for the TV is 100-240VAC 50/60 Hz, please do not connect the power
input port of the TV with the AV power out of the above range.
Keep the insulated part of the plug when you are unplugging the power cord, do not directly touch
the metal part of the cord.
QUICK START GUIDE
· · Connection
1. Connect the electrical network and the antenna.
2. Press the button on the remote control to turn on the TV from standby mode.
· · Initial setup
When the TV is initially turned on, a sequence of on-screen prompts will help you configure the
basic settings.
1. Select the desired OSD (On Screen) language.
Press the / / /
2. Select the appropriate country.
Press the / / /
ning Channels.
button, then press the OK button.
button to select the country, and then press the OK button to Start Tu-
95