Rear Panel - LD Systems LDMEI1000G2 Manual De Usuario

CONNECTIONS, CONTROLS, AND INDICATORS:
TRANSMITTER:

Rear panel

1
1
LOW VOLTAGE CONNECTOR
Power supply connector for 12 - 18V DC (included).
2
BALANCED INPUT LEFT / RIGHT
Left and right-hand balanced inputs (XLR / 6.3 mm jack combo). In the mono mode, only the right input
(RIGHT) may be used.
3
PAD
Switchable level attenuation for high input level.
Switch in position -12 dB: Attenuation of the input signal by 12 db
Switch in position 0 dB: No attenuation of the input signal.
4
ANTENNA
TNC antenna connector 50 Ohm.
BELT PACk RECEIVER
BELT CLIP
Clip the receiver to your belt or a suitable strap. For optimum fit, the
clip should always be pushed all the way over the belt and/or strap (see
illustration).
8
2
Battery replacement
To replace the batteries, press gently on the marked spots on the sides
of the battery cover and flip it forward. Remove the batteries, insert two
new AA-batteries (for orientation please see the illustration in the battery
compartment) and close the cover. Remove the batteries when the device
is not in use for an extended period.
SET
2
3
POWER
4