Mensajes Del Sistema Exclusivo - Hammond XK-1 Manual De Usuario

96
Apéndice

Mensajes del Sistema Exclusivo

Memory Dump
1.Each Packet
F0 System Exclusive
55 SUZUKI ID
00 Device ID
10 Model ID MSB
15 Model ID LSB
11 Command: Data Packet
[TYPE] Data Type
02h= Setup Dump
[PNH] Packet Number MSB
[PNL] Packet Number LSB
[DATA] 64 Bytes Data
128 Bytes nibblized ASCII
ex: 7Eh = 37h, 45h
[CHD] Check Digit
Lower 7 bits of XOR [DATA]
F7 End of Exclusive
2.Acknowledge
F0 System Exclusive
55 SUZUKI ID
00 Device ID
10 Model ID MSB
15 Model ID LSB
14 Command: Acknowledge
Result:
[AK]
[PNH] Packet Number MSB
[PNL] Packet Number LSB
End of Exclusive
F7
3.Hand shake communication
Master
Packet 0 ->
<-
Packet 1 ->
<-
.....
Esta unidad esperará unos 20 milisegundos si no se recibe
This device will wait for 20ms if no acknowledges
'acuse de recibo' (Acknowledge), transmitiendo los próximos
is received and transmit the next data of the
datos del paquete (One Way Transfer).
packet number. (One Way Transfer)
NRPN Switch
F0 System Exclusive
55 SUZUKI ID
00 Device ID
10 Model ID MSB
Model ID LSB
15
02 Command: NRPN Sw.
[DATA] 00h=Off, 7Fh=On
F7 End Of Exclusive
Cuando esta unidad recibe este mensaje, cambia Tx&Rx
When this device receives this message, switch
NRPN en Control Channel.
Tx&Rx NRPN in Control channel.
HAMMOND XK-1 Manual de Usuario
00h=OK
05h=Check Digit Error
06h=Receive Protected
Slave
Acknowledge 0
Acknowledge 1
Mode Setting Exclusive Message
Full Parameters Reset
F0 System Exclusive
55 SUZUKI ID
10 Device ID for DT1
42 Model ID for DT1
12 Command: DT1
40 Address MSB
00 Address
7F Address LSB
7F Reset
42 Check Sum
F7 End of Exclusive
Cuando esta unidad recibe este mensaje, se reseteará su valor al When this device receives this message, it is reset to
estado original de 'Full Paramater', quedando preparado para
the initial status of Full Parameter, and gets ready
recibir datos de forma correcta. Tarda unos 50 milisegundos en
for receiving
procesar este mensaje, hasta procesar el próximo.
the music data for the this device correctly.
It takes about 50ms to process this message.
Take an interval before the next message.