switel TVL300 Manual De Instrucciones página 14

Pairing / restore the connection
In a few cases, due to external influences, the connection between transmitter and
receiver may be lost. To restore it, please follow the following instruction.
1 Unplug the main adaptor to turn off the transmitter,.
2 Switch the On/Off switch on the headset receiver to ON position.
3 Press and hold the headset receiver microphone button for about 5 seconds, the blue
LED on the headset receiver flashes quickly.
4 Connect the transmitter to the power source (plug in the power adapter again). The
connection is restored and the blue LED on the headset receiver lights up constantly.
Changing the rubber ear buds
Two pairs of ear buds are delivered with the device. One pair is already mounted on the
headset.
1 For changing the ear buds pick the mounted ear buds at the end and tear them off
simply.
2 Position the spare ear buds onto the "open ends" and let them snap into place.
Troubleshooting
No sound
- Ensure that the receiver power ON/OFF switch is switched to ON.
- The charge level of the battery inside receiver may be too low. Recharge the battery
for approx. 3 hours.
- The receiver output level is set too low. Adjust the volume to a suitable level.
Distortion
- The charge level of the battery inside the receiver may be too low. Recharge the
battery for approx. 3 hours.
- The receiver may be too far away from the transmitter. Move closer to it.
12