Connection And Setup - Kenwood KCA-iP500 Manual De Instrucciones

Connection and Setup

Connection
iPod (commercially available)
• For instructions on how to connect KCA-iP500
to Control unit, see the Instruction Manual for
Control unit.
Included parts for installation
• Double-stick tape (45mm X 45mm) ...............................1
Power supply function
KCA-iP500 supplies power to the connected iPod
and charges its battery while playing music.
However, the Control unit must be turned on.
4
|
KCA-iP500
Rear side of Control unit
CD changer input
KCA-iP500
Conversion box
Installation
• Install iPod in an appropriate location such as the
glove compartment.
Double-stick tape
(included)
・ Install the conversion box as far as possible from
the center unit. Noise may be generated during
radio reception.
• Avoid placing iPod where it could fall. The iPod
may interfere with driving operation of the vehicle
resulting in an accident.
• Route and install cables so that they are not
exposed to direct sunlight. Cables exposed
to direct sunlight are deformed and becomes
unusable.
• Avoid installing the conversion box where it may
get wet.
• Secure the cables with commercially available
cable clamps as necessary.