Usb Recording - Classic Phono TCD-2500 Manual Del Usuario

2) Press the PLAY.MODE button or PROGRAM button to program the next track. Repeat
this operation to program the track sequence.
3) In MP3 mode under CD/USB operation, the setting procedure of MP3 memory is the
same as that of the CD memory mentioned above under 1) and 2).
4) Press the PLAY/PAUSE button to play the stored tracks, press UP/F-F or DN/F-R to
select a track in the sequence saved.
5) Press the STOP button twice to leave the program mode. The entire program stored in
memory is cancelled.
NOTE: You can store a total of 99 MP3 tracks and 20 CD tracks.

USB RECORDING

1) CD RECORDING
Plug a U-disk into the USB socket. Then press the CD/USB button, place a CD into the
CD drawer and play the track that will be recorded. Press the RECORD button twice to
start recording, the USB icon will flash. The song number and folder number of your
recorded track will be shown on the screen, it will continue to record the next track until
you press the STOP button to finish.
2) Mp3 DISC RECORDING
Plug a U-disk into the USB socket. Then press the CD/USB button and place an MP3 disk
into the CD drawer; the recording procedure is the same as that of CD recording
mentioned above under 1).
3) PHONOGRAPH RECORDING
Plug a U-disk into the USB socket. Then press the PHONO button, play the phono that will
be recorded and set the tone arm to the right place. Press the RECORD button twice to
start recording, press the STOP button to stop recording when you finish recording.
NOTE: Recording will fail if you press the STOP button during the recording.
4) Press the DELETE button one time, DEL will be shown on the display.
Press the DELETE button again to confirm to delete the track that was playing.
11