Troubleshooting - Shinco SPF3-09C Manual De Usuario

Error-detecting code
E1
E2
E4
FUSE PARAMETERS
Specification: Φ5×20mm
Voltage: 250VAC
Current: 3.15A
TROUBLE-SHOOTING
In case of any of the following trouble, please contact professional maintenance personnel
in time.
TROUBLE
The A/C doesn't Not plug in
work
The display panel displays
"FL"
Time OFF function is started
The A/C starts Direct sunlight
frequently
Doors and windows keep
open; there are lots of people
or heat source in room
Filter screen is very dirty
Air inlet or air outlet is blocked
Big noise of the The A/C is placed unevenly
A/C
The compressor Its delay protection is started
doesn't work
Notice: When there is any abnormal to the A/C, turn it off and unplug, and then
contact professional maintenance personnel.
The above technical parameters are subject to change without notice.
Multi-functional defection
Error of the coil's temperature sensor
Error of indoor temperature sensor
Anti-freezing protection: temperature of the coil is too low and
the whole A/C is off. When temperature excesses 8℃, the
protection is released and previous working state is recovered.
CAUSE SOLUTION
Plug in
Restart the A/C after power off and
draining, then it will become normal
The A/C can be restarted 3 minutes
after being turning off.
Draw the curtain
Close doors and windows, remove
heat source
Clean or replace it
Remove the stem
Place it at even and firm ground,
avoid shaking
Wait for 3min., turn
temperature decreases
on it after
EN 10