Extension Poles - unGer Stingray Manual Para El Usuario

3.1 Installing the Glass Cleaner Pouch
• Open the compartment on handheld unit by sliding the black button
back and remove the lid (picture 1).
• Take a new pouch out of the box and screw off the protective cap.
• Be careful not to apply too much pressure to the pouch as contents
can spray once the safety cap is removed.
• Push the pouch onto the connector at the top of the compartment.
You can rotate the connection stem up to have better access (picture 2).
Always change the pouch with the cleaning head facing up.
• Push the pouch as far as possible onto the connection stem to
prevent leakage (picture 3).
• Push the pouch and pin down so that it fits into the compartment.
• Replace the lid and confirm that the black button is locked into place
(picture 4).
• Attention: When the pouch is removed, prevent the liquid from
leaking by replacing the protective cap. Clean and dry any spills
with a clean cloth.
• The batteries included with the unit have been approved for
international transport/shipping.
3.2 Assembly of the Pad
• The system is equipped with a triangular shaped microfiber pad.
• The pad provides maximum cleaning power in combination with the
Stingray Glass Cleaner.
• Put the microfiber pad onto the padholder. Fix it in place with the
elastic bands in each corner.
• Once the pad is dirty, take it off and wash it.
Please see care label on pad.
• The area that can be cleaned with one pad will vary depending on the
condition of the surface being cleaned.

3.3 Extension Poles

• The handheld unit can be used as a hand tool for easy to
reach surfaces (picture 5).
• The handheld unit can be extended to reach higher or hard
to reach surfaces using the available short (1.5'/.5m) or
long (3.5'/1.1m) extension poles (see page 4).
• The system is designed to use a maximum of two long and
one short extension poles.
Never exceed maximum recommended length. Unger is
not liable for any damages or injuries resulting from the
failure to follow these instructions.
• When adding extension poles, be sure locking pins are
locked into corresponding pin holes (picture 6).
• To unlock, press the locking pin and separate the extension
poles (picture 7).
3.0 Installation
1
2
3
4
5
6
7
5