Using The Controls; Normal Sounds - Kenmore 106.8955 Serie Manual De Uso

2. When the desired thickness is reached, the ice sheet is
released and slides onto a cutter grid. The grid divides the
sheet into individual cubes.
3. The water containing the rejected minerals is drained after
each freezing cycle.
4. Fresh water enters the machine for the next ice making
cycle.
5. Cubes fall into the storage bin. When the bin is full, the ice
maker shuts off automatically and restarts when more ice is
needed. The ice bin is not refrigerated, and some melting
will occur. The amount of melting varies with room
temperature.
NOTE: As the room and water temperatures vary, so will the
amount of ice produced and stored. This means that higher
operating temperatures result in reduced ice production.

Using the Controls

1. To start ice production, press ON/OFF.
2. To stop ice maker operation, press ON/OFF.
NOTES:
Pressing the On/Off button does not shut off power to the
ice maker.
Allow 24 hours to produce the first batch of ice. Discard the
first 2 batches produced.
Acceler-Ice Mode
Select the Acceler-Ice feature when you have an upcoming
need for a large amount of ice and the ice bin is low or empty.
Acceler-Ice mode will produce a greater quantity of ice in a
24­hour period.
Press ACCELER-ICE while the ice maker is on. The indicator
light will illuminate.
Press ACCELER-ICE again to turn off the Acceler-Ice feature.
The indicator light will turn off.
The Acceler-Ice mode will be on when you first turn on the
product. It will turn off after 24 hours. To turn Acceler-Ice
back on, press ACCELER-ICE.
Clean
It is recommended that you clean the ice maker when the
"Cleaning Needed" light is illuminated or 9 months has elapsed
or ice production decreases significantly. To clean your ice
maker, see "Ice Maker System" in the "Cleaning" section.
Door Ajar Alarm
The Door Ajar Alarm feature sounds an alarm when the ice
maker door is open for 5 minutes. The alarm will repeat every
2 minutes. Close the door to turn off. The feature then resets and
will reactivate when the door is left open again for 5 minutes.

Normal Sounds

Your new ice maker may make sounds that are not familiar to
you. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal.
Hard surfaces such as floors, walls and cabinets can make the
sounds seem louder than they actually are. The following
describes the kinds of sounds that might be new to you and
what may be making them.
You will hear a buzzing sound when the water valve opens
to fill the water pan for each cycle.
Rattling noises may come from the flow of the refrigerant or
the water line. Items stored on top of the ice maker can also
make noises.
The high-efficiency compressor may make a pulsating or
high pitched sound.
Water running over the evaporator plate may make a
splashing sound.
Water running from the evaporator plate to the water pan
may make a splashing sound.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your ice maker.
You may hear air being forced over the condenser by the
condenser fan.
During the harvest cycle, you may hear a "thud" when the
ice sheet slides from the evaporator onto the cutter grid.
When you first start the ice maker, you may hear water
running continuously. The ice maker is programmed to run a
rinse cycle before it begins to make ice.
If the ice maker is connected to a water supply pressure in
excess of 60 psi, you may hear a loud sound during water
filling associated with the flow of water through the inlet
valve. Call a licensed, qualified plumber to determine the
best method to reduce the supply water pressure (50 psi is
recommended).
15