Página 1
Large Ceiling Mount Flat Panel Ceiling Mount INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES MANUEL D’ INSTRUCTIONS CAUTION: THE MAXIMUM LOADING WEIGHT IS 125 LBS. USE WITH PRODUCTS HEAVIER THAN THE MAXIMUM WEIGHT INDICATED MAY RESULT IN INSTABILITY AND POSSIBLE PERSONAL INJURY. Max Screen Size: 70”...
QUESTIONS? NEED HELP? PLEASE CALL ¿NECESITA AYUDA? LLÁMENOS. BESOIN D’AIDE? VEUILLEZ APPELER 1-602-674-1000 DISCLAIMER – WARNING INFORMATION Disclaimer –. MW PRODUCTS has extended every effort to ensure to accuracy and completeness of this manual. However, MW PRODUCTS does not claim that the information covers all installation and or operational variables.
Página 3
HARDWARE PRODUCT NUMBERS M4 x 12 M5 x 12 M6 x 15 M8 x 15 M4 x 25 M5 x 25 M6 x 25 M8 x 25 8 mm LAG SQUARE STEEL STEEL Security Allen Key Security Allen Key BOLT M5 Set Screw WASHER SPACER...
Página 4
STEP 1- FLAT BACK FLAT PANEL (UNIVERSAL MONITOR PLATE) Connect Universal Monitor Plate to flat panel Conecte el adaptador al monitor Connectez l'adaptateur au moniteur Square washer STEP 1- CURVED BACK FLAT PANEL (UNIVERSAL MONITOR PLATE) Connect Universal Monitor Plate to flat panel Conecte el adaptador al monitor Connectez l'adaptateur au moniteur Spacers can also be used to...
Página 5
STEP 1- USE M8 STEEL WASHER IF THE PHILLIPS SCREWS FROM THE MONITOR KIT ARE TOO LONG Diagrams show three options for using additional washers if hardware screws are too long to properly tighten into back of flat panel television.
Página 6
STEP 1- CENTER UNIVERSAL MONITOR PLATE Monitor Plate must be centered (horizontal plane) on back of flat panel Secure vertical rails to horizontal chrome rod on Monitor Plate with pre-installed screws.
Página 8
STEP 3- WOOD STUD INSTALLATION Wood Pilot Pilot Hole Size Pilot Drill Depth 7/32” inch 2.75 inch 5.5 mm 70 mm...
Página 9
STEP 4- ATTACH THE PIPE ASSEMBLY AT THE CEILING PLATE. M5 Set Screw Security Allen Key 2.5mm Adjust the pipe assembly to Rotate the pipe assembly to the best direction , then tighten the ceiling plate, assemble the the set screw with the security two parts.
Página 10
STEP 5- LIFT AND HANG THE MONITOR PLATE AT THE PIPE ASSEMBLY. Secure Nylon Nut and Washer on a) Rotate handle clockwise as far as Monitor Plate to Pipe possible. Assemble (snug b) Pull handle to side laterally tension only) (against spring tension) and rotate counter-clockwise as far as possible.
Congratulations! Installation complete WARRANTY INFORMATION This warranty applies to US Residents who purchase from an authorized MW PRODUCTS Dealer. MW PRODUCTS products are covered against defects in materials and workmanship for 5 years. MW PRODUCTS will repair or replace the defective component or product, at its sole discretion. Failure to follow product care instructions from MW PRODUCTS will result in void of warranty.