Safety Warning - CMT ORANGE TOOLS CMT-ENLOCK1 Manual De Instrucciones

SAFETY WARNING

This list of do's and don'ts is not exhaustive and is not a substitute for common sense and best
practices.
Woodworking machines are dangerous; it is important to observe all safety instructions while
operating this machine.
• Always wear ear and eye protection.
• Always unplug the routing machine from the power source before making adjustments.
• Always use a licensed electrician for any installation or electrical repair work.
• Do not wear loose clothing, jewellery or other loose ornamentation.
• Long hair should be protected by netting or other means to prevent ingress into the machines
working parts.
• Keep all safety guards in place and well maintained.
• Ensure all adjusting keys, spanners and tools are removed before machine is
switched on.
• Keep children and unauthorised persons away from machine even when not in use.
• Do not use machine for any other purpose than that for which it was designed.
• Do not use excessive force, or exceed capacity of machine by attempting to take too large a cut.
• At no time should machine be unattended whilst in operation.
• Do not put hands inside machine whilst it is running.
• Wood dust is a health hazard; ensure correct dust extraction is used
• Cutter blades should be kept sharp at all times. Blunt blades are a major cause of
accidents and machine failure. Damage to the machine caused by blunt blades is not covered
by warranty.
• This machine should be used in an area with good lighting and ventilation.
• Keep the floor and adjacent areas around the machine dry and clean.
• Always maintain a balanced stance when operating this machine.
• Do not operate this machine whilst on medication or under the influence of alcohol or drugs.
2
www.cmtutensili.com