Portamate PM4000 Manual Del Operador página 5

Figure 4
Figure 5
OPEN
LOCKED
Figure 6
Parts List
#3040 Offset Mounting Bracket
W M8 x 16mm Carriage Bolt (2)
X M8 Flat Washer (2)
Y M8 Lock Washer (2)
Z M8 Hex Nut (2)
Also Available:
Kit No. J-210
Mounting Kit for Miter Saws and/or Other
Power Tools with 3-Hole Mounting Pattern
Comes with everything above and adds bracket
(Part #J105) which connects both #3040 Offset
Mounting Brackets.
6. Attach the (2) machine mounts to the saw using M8 x 35mm carriage bolts
 at each saw mounting point. See Figure 4. From the bottom, pass the
carriage bolt through the slot in the machine mount, through the mounting
hole and secure with flat washer , lock washer N and nut O. Hand tighten
only. If the saw has an irregular mounting holes see Figure 7.
7. Carefully lift the saw and place onto the miter saw stand. Be sure the hook
end of the machine mount locks under the top tube as shown in Figure 5. The
spring loaded handle should lock under the opposite top tube. Figure 6.
8. Slide the saw forward or back along the machine mount to best balance the saw
on the stand. Secure the saw by tightening the carriage bolts installed in Step 6.
Instructions for
Irregular Saw Mounting Holes
Secure Offset Mounting Brackets as shown below.
Note: Brackets can be used on the front or rear of the Machine Mounts.
To Order
(if not included)
Kit No. J-104
Mounting Kit for Miter Saws and/or Other Power
Tools with an Inset Mounting Hole Pattern
Figure 7
X
Y
Z
5
Call: 1-866-588-0395
W
#3040