Silhouette DKC055D1SSPRO Manual Del Propietário página 9

INSTALLATION INSTRUCTIONS
Coupler Components
13
12
11
10
1. Ball retainer
2. Nylon coupler ball
3. Nickel plated probe
4. Probe seal
5. Hex nut
6. Tail piece
7. Check valve
8. Coupler body
9. Coupler seal
10. Handle assembly
11. Pressure relief assembly
12. Handle hinge pin
13. O-rings
Note: The coupler included with the appliance is a
standard American Sankey coupler which should fi t
all domestic kegs.
If using an imported or non-standard keg, it will be
necessary to purchase a coupler that can fi t the keg.
How to Tap a Keg of Beer
Make sure the CO
the regulator is in the closed position.
1
Pull out and release the pressure release valve on
2
the coupler to purge any air pressure.
3
Make sure the beer tower faucet handle is in the
4
closed position.
Insert the keg coupler into the locking neck of the
beer keg and turn it clockwise to lock into position,
making sure the keg coupler handle is in the closed
position, with the handle up.
5 Pull coupler handle out and downward until it locks
into its open position. The teeth on the underside of
6
the coupler will bite into the locking neck of the beer
7
keg.
8
Note: If a keg is very tall, it may be necessary to
connect the coupler to the keg before inserting the
keg into the keg cooler.
9
Coupler Closed Position
Coupler Open Position
8
is turned off and the valve on
2
Pressure release
valve
Pressure release
valve