Publicidad
Idiomas disponibles
Idiomas disponibles
EP 2210
PARTS OF THE PRODUCT
1. Transparent lid
2. Large squeezing cone
3. Small squeezing cone
4. Filter sieve with pulp regulator
5. Juice container
6. Guide mandrel
7. Motor section
8. Cable take-up with plug holder
INITIAL OPERATION
•
Before using for the first time please clean
the machine as described under "Cleaning"
below.
•
Unwind the mains lead on the base and
assemble the machine according to the
depiction of the individual parts.
USING THE MACHINE
Assembling and releasing the jug
•
Assemble the pot by placing it over the guide mandrel and turning it
in a clockwise direction until it locks in place.
•
Release the jug by turning it through in an anticlockwise direction
on the base and lifting.
Replacing and removing the conical press
The small press is placed directly on the drive axle until it is flush with
the filter. If you want to use the large cone you must place it on top of
the small one.
1. Place the device on a firm and fl at surface. Position it such that it
cannot tilt over.
2. Place the jug in the centre of the housing (position the recess in the
jug over the drive axle) and turn until tight.
3. Now insert the filter into the jug.
4. Insert the plug in a duly installed 230 V/50 Hz socket.
5. Halve the citrus fruit in the middle. Press the fleshy side of one half
of the fruit on to the conical press and keep pressed. The machine
21
Publicidad
