Installation; Batteries Installation; Default Menu Screen; Menu Screen - Gema Cardio-C Manual De Uso

Chapter 2

installation

2.1 batteries installation

1. Open the battery cover
by a screwdriver or a coin.
2. Insert four AA size batteries directly
(as shown in figure 2.1).
z
3. Close the batter cover and fasten it.
Do NOT insert batteries with
their polarities reversed.
Dispose of the used batteries
Σ
IVD
1
according to applicable local
regulations.
PHTHALATES
Note: Protecting films are attached
to the electrodes of device, so please
remove the protecting films before measurement.
Chapter 3

dEFault mEnu sCrEEn

3.1 menu screen

Long time press the " " Power key (lasting for 2 seconds) until a beep sound
is heard to indicate the unit is turned on, then the booting screen will appear,
as shown in the figure 3.1, after that the device enters into the default menu
screen, as shown in figure 3.2. There are 6 entries, press navigation key
to shift focus on them and press "" ok key to go into the selected entry.
Each entry has an icon and it is defined as following:
Measure: detect ECG signal, mean while,
display waveform, HR value, and analyze
the ECG waveform to prompt necessary
information.
review: recall and view the ECG records
stored in this device (including waveform
data and measurement result).
Memory: ECG records management including
storage status check and record deletion.
ENGLISH
Figure 2.1
Version 1.10
Ver si on: 1. 10
Figure 3.1
44