General Power Tool Safety Warnings - Makita DFR540 Manual De Instrucciones

ENGLISH (Original Instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Indicator lamps
6. Check button
7. Lever
8. Stopper base
9. Label on feeder box
10. Fenestella
11. Casing
SPECIFICATIONS
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Explanation of general view
12. Adjusting knob
13. Switch trigger
14. Reversing switch lever
15. Thumb screw
16. Plane bearing
17. Dust cover
18. Bit
19. Feeder box
20. Screw strip
21. Screw guide
22. Driving position
Model
Screw strip
-1
)
Net weight
D.C.14.4 V Model
D.C.18 V Model
DFR540
2.0 - 3.0 kg
D.C. 14.4 V
BL1415N/BL1430/BL1430B/BL1440/BL1450/BL1460B
BL1815N/BL1820/BL1820B/BL1830/BL1830B/BL1840/
BL1840B/BL1850/BL1850B/BL1860B
DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF
Save all warnings and
ENE033-1
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
GEA010-2
CORDLESS SCREWDRIVER
SAFETY WARNINGS
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an
electric shock.
2. Always be sure you have a firm footing.
23. Reverse button
24. Hook
25. Wall
26. Limit mark
27. Front cover
28. Screws
29. Spring
30. Arm
31. Recessed part
32. Carbon brush cap
33. Hole
DFR550
4 x 25 - 55 mm
4,000
424 m
2.1 - 3.1 kg
D.C. 18 V
DFR750
4 x 45 - 75 mm
464 mm
2.1 - 3.2 kg
D.C. 18 V
GEB139-1
5