SEVERIN VL 8632 Instrucciones De Uso página 8

appendix to this manual.
Before using the appliance for the first time
Remove all packaging completely before the
appliance is used for the first time.
Fan-blade unit and grille assembly
- Remove the central grille locking ring
from the motor housing by turning it
anti-clockwise.
- Put the rear grille in position. The two
alignment pins on the motor housing
must fit into the corresponding slots in
the rear grille.
- Fit the central grille locking ring and turn
it clockwise to tighten it.
- Push the fan-blade unit onto the drive
shaft; ensure that the pin on the shaft is
properly engaged in the corresponding
recess on the unit.
- Fit the fan-blade mounting nut and turn
it anti-clockwise to tighten it.
- Place the retaining ring onto the rim of
the rear grille. (The retaining ring locking
screw may have to be loosened).
- Place the front grille in front of the rear
grille into the retaining ring and tighten
the retaining ring screw. Ensure that both
grille rims are correctly positioned in
each of the corresponding recesses inside
the retaining ring.
Tube-assembly mounting
- Place the protective caps on each end of
the base crosspieces. The ends may be
compressed to facilitate fitting the caps,
which click audibly into place.
- Fit the two parts of the base stand into
each other.
- Loosen the screws on the base stand.
- Fit the main support tube and secure it
with the screws on to the base stand.
- Turn the tube locking ring anti-clockwise
to loosen it and push the cover down the
main supporting tube until it sits firmly
on the base stand.
- Pull out the inner support tube as far as
desired; then fit the tube locking ring
and turn it clockwise to tighten it.
- Fit the motor housing onto the tube
assembly and secure it by tightening the
locking screw.
Operation
- Insert the plug into a suitable wall socket.
- To adjust the tilt angle of the fan head,
simply push the head upwards or
downwards. The fan head assembly
automatically locks into its various
positions.
- In addition, the oscillation function can
be engaged by pushing the control knob
in.
- The fan speed is adjustable by means of
the four separate switches in the switch
panel. At the '0' setting, the fan is
switched off.
General Care and Cleaning
●
Remove the plug from the wall socket
before cleaning.
●
To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
●
Do not use abrasives or harsh cleaning
solutions.
- If it becomes necessary, clean the fan
with a dry lint-free cloth only.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
two years from the date of purchase. Under
this guarantee the manufacturer undertakes
to repair or replace any parts found to be
defective, providing the product is returned
to one of our authorised service centres. This
guarantee is only valid if the appliance has
been used in accordance with the
instructions, and provided that it has not
8