Automatic Switch-Off; Using Your Kettle; Cleaning And Care - URSUS TROTTER UT-ZISKA17C Manual De Usuario Y Letra De Garantía

• Attention: if the kettle is overfilled, water may spill out
of the kettle.

Automatic switch-off

The kettle will switch OFF automatically and the power
indicator light (E) will go out when the water has boiled
or the kettle is removed from the base.
When the water has boiled, the kettle will switch OFF
automatically.
If you want to stop the heating process before the water
has fully boiled, simply lift the ON/OFF switch (F) up to
the OFF position.
If the kettle is only filled with a little water, it may take
longer to switch OFF.

Using your kettle

Before using your kettle, you should wipe the inside
and outside the kettle with a damp cloth to remove any
residue from the manufacturing process.
Initial use
· Place the base unit on a flat surface. The base unit must
be dry.
· If the mains cord is longer than necessary, it can be
wound up at the bottom of the base unit.
· Open the lid.
· Fill with cold water up-to the MAX mark.
· Close the lid until it engages. The automatic switch-off
can only function reliably with the lid closed properly.
Wipe excess water off the kettle.
· Place the kettle onto the base in any position you wish.
· Plug the mains plug into a wall socket.
· Press the ON/OFF switch down to the ON position, the
power indicator light will light up and the kettle will start
heating up.
· The ON/OFF switch only operates when the kettle is
on the base unit.
· Do not drink water from the first 2 boiling cycles.
· Be careful not to spill any water onto the base unit.
· To reheat water, check the water level to ensure it is
above the MIN mark water level. If necessary, add more
water, then place kettle back onto base unit. Press the
ON/OFF switch down to the ON position. You can switch
to OFF position when the water reaches your desired
temperature on the thermometer (H) by lifting up the
On/OFF switch.
· When refilling water, be careful of hot steam when
lifting/opening the lid.

Cleaning and care

· Always disconnect the kettle from the mains power
outlet before cleaning.
· Allow the kettle to cool down before cleaning.
· Never clean the kettle and base unit under running
water or immerse it in water.
· Occasionally rinse the interior of the kettle with clean
water.
· Clean the exterior of the appliance only using a damp
cloth. Do not use any caustic or abrasive cleansing
agents.
Descaling
· Half fill the kettle with tap water and add the juice of 1
lemon to the water.
· Boil this mixture and allow it to stand for 15 minutes.
Re-boil the mixture and allow it to stand a further 15
minutes. Re-boil this mixture a third time then rinse the
kettle thoroughly.
· Alternatively a commercially available descaling solution
can be used. Ensure to follow the instructions supplied
with the cleaning solution.
Disposal
Packaging material
The packaging materials are environmentally friendly and
can be recycled. The plastic components are identified
by markings, e.g.>PE<,>PS<, etc.
Please dispose of the packaging materials in the
appropriate container at community waste disposal
facilities.