Battery Pack And Charger; Charging The Battery Pack; Battery Charging Procedure - Craftsman 151.74936 Manual Del Usuario

■ Verify that the battery pack is removed
and the switch is in the OFF position
before inspecting, adjusting, or performing
maintenance on any part of the sweeper.
■ Read, understand, and follow the
instructions contained in the section entitled

Battery Charging Procedure.

BATTERY PACK AND CHARGER

BECOME FAMILIAR WITH THE CHARGER
See Figure 4, page ii
Before attempting to use this charger,
become familiar with all of its operating
features and safety requirements.

CHARGING THE BATTERY PACK

See Figure 5, page iii
WARNING!
■ If any part of the charger is missing or
damaged, do not operate it! Replace the
charger with a new one. Failure to heed this
warning could result in possible serious injury.
■ Check the voltage! The voltage must
comply with the information on the rating
label.
BATTERY CHARGING PROCEDURE
■ Align the battery pack to the slots on the
charger and slide it in until it locks in place.
■ Connect the charger to the power supply.
■ Allow sufficient charging time (see Product
Specifications), and then disconnect the
charger from the power supply.
■ Press the release button on the battery
pack and remove it from the charger.
ASSEMBLY
FOR SWEEPING
See Figure 3, page ii
■ Align the widest end of the sweeper tube
with the front opening on the sweeper.
■ Slide the nozzle over the sweeper outlet
opening until the latch on the sweeper is
inserted into the opening on the nozzle and
snaps into place.
NOTE: It is normal for the battery pack and
charger to become warm (but not hot) during
charging process. If the battery does not
charge properly, check to make sure the
electrical outlet is "live".
Always charge the battery before storage!
WARNING!
leave the battery connected with the charger
for more than 24 hours!
■ Do not use other battery chargers. The
battery charger supplied is specifically
designed for the Lithium-Ion battery used in
this garden appliance.
■ Check the main power supply! The voltage
of the power supply must correspond with the
data on the nameplate of the battery charger.
Battery chargers operate on 120V.
■ The battery is equipped with a temperature
monitor that allows charging only within a
temperature range between 23
This ensures an optimum battery service life.
NOTE: The battery is supplied partially
charged. To ensure full capacity of the
battery, charge the battery in the battery
charger before using the product for the first
time. The Lithium-Ion battery can be charged
at any time without reducing its service life.
Interrupting the charging procedure does not
affect the battery.
10 ― English
To reduce risk of fire, never
o
F and 122
o
F.