How To Operate - TECshow GREY II 8 Manual De Usuario

8. HOW TO OPERATE

1. Above all, it is necessary to confirm power
voltage.
2. Make sure this appliance power switch is off
when connecting the plug of power cord with
outlet.
3. Set easy controls to the positions stated belows
to avoid lord blasts, Loud blasts may couse
damage for your speaker system or you rears
when you are wearing headphone. Master fad-
ers L/R, Sub faders AUX, Effect fader and Each
channel faders.
• Gain control: Turn to the left completely.
• Hi, Mid, Low: Turn to the center position.
• Aux 1-2 & Effect control: Turn to the left com-
pletely.
• Pan control: Turn to the center position.
• Set other turn to the left completely.
4. Push power switch marked(1), then the LED will
7. INSTALLATION
FIGURE 1
UNBALANCES 1/4" PLUG
P. 10
Tecshow Grey II 8 | English version
be turned on when start working.
5. Set Master faders L-R to the position between
min & mid, after working.
6. Set a certain Channel faders which you want
to use to the position between min and mid.
After that, Connect input section with external
source.
7. To make sound thur external sources, turn the
Gain control to the right.
8. Adjust tone controls in accordance with your
taste.
9. Adjust between Effect fader control towards
max from min & effect control to the right,
when you want to get echo effect a certain
channel, after set a certain channel, adjust
delay control & repeat control, then you can get
various echo effect sound.
TIP: POSITIVE (hot+)
SLEEVE GROUND (shield)