Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
AHPCL10PRO POWER CONDITIONER STRIP AND MONITOR WITH RACK LIGHT
FRONT PANEL
1
1.
Circuit breaker: when the total current draw of the switched rear outlets and the front panel unswitched
convenience outlet exceeds 10 amps the circuit breaker will trip. Disconnect one or more pieces of your rack
equipment to reduce current draw. To reset the circuit breaker let it cool for a minute, then push it in gently
until it latches.
2.
Dimmer control: this adjusts the pull-out LED lights' brightness.
3.
LED rack lights: the 5-LED lights switch on automatically when pulled out. To turn them off slide the barrels
back in. Use the Dimmer control (see 2) to set the brightness level.
4.
Voltmeter: 3-digit LED display to visually monitor the incoming line voltage.
WARNING: EXTREME VOLTAGE SWINGS CAN SEVERELY DAMAGE THE CONNECTED EQUIPMENT. IF THE
VOLTMETER DISPLAY READS OVERLY OR RAPIDLY CHANGING VALUES DISCONNECT THE AHPCL10PRO AND
LOCATE THE SOURCE OF THE PROBLEM.
5.
Vent: the front panel vent openings provide convection cooling of the AHPCL10PRO.
6.
Ammeter: t3-digit LED display to visually monitor the amount of current drawn by the connected equipment.
WARNING: EXTREME CURRENT SWINGS CAN SEVERELY DAMAGE THE CONNECTED EQUIPMENT. IF THE
AMMETER DISPLAY READS OVERLY OR RAPIDLY CHANGING VALUES DISCONNECT THE AHPCL10PRO AND
LOCATE THE SOURCE OF THE PROBLEM.
7.
Unswitched convenience outlet: this IEC outlet is active whenever the AHPCL10PRO's power cord is
connected to an appropriate mains outlet. It is not affected by the "Outlets" switch (see 8).
8.
Outlets switch: this activates and disables the rear panel outlets. The red status indicator inside the switch
is lit when the rear outlets are enabled.
10
2
3
5
6
4
3
7
8
Publicidad
Tabla de contenido
