Pairing With Bluetooth Devices - Oehlbach BTX 1000 Manual Del Usuario

Operation

Pairing with Bluetooth devices:

1. The BTX 1000 must be switched off before pairing it with a
device for the first time.
2. Now press and hold the function button on the BTX 1000
for 6 seconds until the LED starts to flash red and blue. The
pairing mode is now active.
3. Activate the Bluetooth function on your output device and
search for the BTX 1000. The name of the adapter is
„OEHLBACH BT". Select „OEHLBACH BT".
4. When pairing has been completed successfully the BTX
1000 will flash blue briefly three times every 3 seconds.
You can now start to play any of your audio files via the
BTX 1000.
5. To do this, connect the BTX 1000 to the 3.5 mm jack or
stereo RCA input on your device (e.g. amplifier, AV receiver,
active speaker, car radio, etc.).
6. To switch off the BTX 1000 press and hold the function
button for 4 seconds. After 5 minutes of inactivity (in standby
mode) the BTX 1000 will switch off automatically.
Additional operating instructions:
∙ If you only press and hold the function button briefly and the
LED flashes red twice every 3 seconds, it means the BTX
1000 is switched on but it is not in the pairing mode.
To activate this mode you will need to press and hold the
function button for 6 seconds when the adapter is switched
off.
14