Amplicomms NL 200 Manual De Instrucciones página 14

Using the NL200
3 Using the NL200
The NL200 implements an induction loop
system which operates together with your
hearing aid. In order to be able to use the
NL200, you must hang it around your neck
and establish a connection to your mobile
phone.
The individual functions provided by the
NL200 are described below.
Registering the NL200 on the mobile phone
Prior to using the NL200 for the first time, it
must be registered on the relevant mobile
phone.
1. Switch on your mobile phone's
BluetoothE function.
2. Press and hold the Power button (4) on
the NL200 until the Status LED (3)
flashes blue and red alternately.
0844 800 6503 (Using an UK landline, at the time of going to print: calls cost 6p for connection charge
14
It is essential to pay attention
to the safety information in
Chapter 1.
and then 5p a minute. Mobile costs may vary.
3. Activate the search function for
BluetoothE devices on the mobile
phone.
4. Wait until the mobile phone has found
the NL200.
5. The mobile phone should now display
the device with the name KSY−01".
6. Select this device and enter the code
0000".
7. If registration has been completed
successfully and the NL200 is linked to
your mobile phone, the Status LED (3)
flashes blue.
Switching the NL200 on
The next time you intend to use the NL200,
there is no need to complete the procedure
for registration on the mobile phone again.
After the NL200 has been switched on, it is
automatically registered on the relevant mo-
bile phone.
The BluetoothE function
must be activated on the
mobile phone.