Bionaire BLI601 Manual De Instrucciones página 9

"Heating/Cooling" Dial
• This product may be used either to heat or
cool and humidify the environment. Choose the
desired function by turning the corresponding
dial on the side of the appliance.
HEATING
COOLING
Control Panel
• "Off" Button " ",: Press this button to stop the
product (when it is in "Cooling" mode). In order
to turn the product off while in "Heating" mode,
turn off the power switch, which is found on the
back of the device.
• "Speed" Buttons" , , ": Press the buttons
corresponding to the desired speed (only for
"Cooling" mode). When using the "Heating"
function, the air speed is constant and cannot
be changed.
• "Oscillate" Button: Press this button so
that the louvers directing the outlet of air will
oscillate and distribute the air throughout the
environment. Press it again to turn off the
oscillation function.
Note: You can also manually change the
direction of the horizontal louvers to choose the
direction of air flow (up or down).
• "Cooling" Button (only applies to "Cooling"
mode): Press this button to activate the air
pump, which will moisten the honeycomb filter
and begin to cool the system. Pressing this
button again will turn off the water pump.
Important:
The "Cooling" function can only be used if there
is water in the tank (above the minimum level).
• The product's ability to function is directly
related to the relative humidity of the air. A drier
environment will result in greater refreshment
when using the "Cooling" function. The "Cooling"
button will not activate the water pump when
the selector is in "Heating" mode. The pump
will only be activated if the "Cooling" mode is
selected.
Gel Container
• The product comes with a freezable gel container,
which helps the water tank's cooling process and
causes the device to generate cold air.
Warning! Keep the gel container out of reach of
children and pets. It contains chemical substances
that could be harmful if ingested.
How it Works:
1. Place the gel container in a freezer until it is
completely frozen (approximately 4 hours).
2. Place the (frozen) gel container inside the water
tank horizontally.
Note: When adding the gel container to the
water tank, the tank's water level will rise.
Always make sure not to exceed the maximum
water level in the water tank (including gel
container and water).
Water Tank
1. Never allow the device's water level to fall below
the minimum limit.
2. Never fill the appliance's water tank above the
maximum limit, as the water could spill out and
cause electrical shock.
3. In order to improve the effectiveness of the product
to cool the air, place ice or the gel container in the
water tank; however, keep in mind that the water
level should never rise above the maximum limit as
indicated on the tank.
Note:The product has an easily removable water
tank. Pull it away from the device carefully, detach
the pump, and remove the tank. Remember that
this should only be done when the appliance is
unplugged.
MODES
Selecting the "Heating/Cooling" Modes"
• In order to select the desired function, just turn
the control on the side of the appliance.
• "Heating" and "Cooling" modes cannot be used
simultaneously.
"Cooling" Button (Only Applies to
"Cooling" Mode)
The "Cooling" " " button activates the water pump
and causes the water to pass through the honeycomb
filter, releasing cold air into the environment. To
activate this function, press the "Cooling" button. To
deactivate it, press the button again.
3