Princess 01.338902.01.001 Manual De Usuario página 7

2. Press "AUTO" button on remote control to direct the cleaner to
charging station. (Fig B)
USE
Remote control
ü Point the remote control at the main unit when pressing a button
1. Time setting: Press "CLK" button. Press direction buttons to set
the time. When you have selected the time, press "CLK" again.
2. Cleaning function: Press "ON/OFF" button.
3. Sleep function: Press "ON/OFF" button for 5 seconds.
4. Cleaning mode selection: Press "MODE" button. The LCD display
will show in which mode the cleaner currently is. (For details see
Cleaning Modes)
5. Scheduling function: Press "PLAN" button to set up the schedule
(For details see Scheduling Cleaning section)
6. Auto charging: Press "HOME" button to direct the cleaner to the
charging station automatically.
7. Direction buttons: Use to change the direction of the cleaner
manually.
Main body
Cleaning button part
A. Switch on the robot, CLEAN button indicator will be in gradual
blue.
B. Touch CLEAN button, the robot will have 3 beeps and the indicator
will flash in blue, then it will start cleaning if the robot is in good state.
And the indicator will keep in blue during cleaning.
C. If the robot is malfunctioned, its indicator will be in different status
(details please take reference in troubleshooting).
D. The indicator will flash in red when the robot with low power.
E. During charging (robot on charging home base or connected by
charging adaptor), CLEAN button indicator will get red gradually.
After fully charged, the robot will have 5 beeps and CLEAN button
indicator will turn blue.
F. When the robot is successfully scheduled, the indicator will be pink
for two seconds. (Press PLAN button for seconds to check whether
robot has already scheduled. If yes, the indicator will in pink for two
seconds. Otherwise, the indicator will have no color change.)
Starting up / Pause / Sleep
1. Starting up
A. Power on the switch at bottom side of the robot, and CLEAN
button indicator will be in gradual blue.
B. Press CLEAN button on main body or on remote controller to start
cleaning. The robot will have 3 beeps, and the CLEAN indicator will
be in gradual blue.
Instruction manual
EN
7