Changing The Soldering Tip; Temperature Calibration - ERSA i-con nano Instrucciones De Uso

Changing the soldering tip

Various soldering tips can
be used with the i-CON nano
soldering station. In this
way, the soldering station
can be adapted to various
areas of operation. See
page 51.
More soldering tips are avail-
able from the ERSA dealer.
Downloadable overview of
standard tips:
http://i-tool.de/mediothek/
pdf/3ba00172_spitzen.pdf
Downloadable overview of
special tips:
http://i-tool.de/mediothek/
pdf/3ba00176_spc_itips.pdf

Temperature calibration

If the set temperature and
the actual temperature of
the soldering tip do not con-
cur, then the temperature
can be calibrated in order
to resume work at exact
soldering temperatures.
Default value: 0
Value range: -70 to +50 °C
-126 to +90 °F
13 Switch off soldering station
and allow soldering tip to
cool to approx. 40 °C / 104 °F.
14 Screw soldering tip onto
the knurled section of the
soldering iron.
15 Remove soldering tip from
soldering iron.
16 Place desired soldering tip
onto soldering iron.
17 Fit soldering tip with knurled
section onto soldering iron
and check for correct fit.
18 Switch on soldering station.
ATTENTION! Soldering
tip is hot! Risk of burning
yourself!
19 Select reference value for
calibration at the soldering
station.
20 Determining actual tem-
perature using a digital
temperature-measuring
instrument.
21 Calculating deviation be-
tween reference value and
actual value.
22 Press both keys briefly to
call up the calibration menu.
23 Setting temperature using
the keys in accordance
with the deviation.
24 Wait five seconds to save
the value.
9
English |