Appropriate Use; Product Description; Technical Specifications - Elektrotechnik Schabus SHT 5000 Instrucciones De Uso

3. APPROPRIATE USE

The SHT 5000 water detector is a device for recognizing changes in water conditions. As
soon as the sensor has contact with water, an acoustic and an optic alarm signal sounds and
warns you against unexpected water ingress.

4. PRODUCT DESCRIPTION

Up to four water sensors or float switches can be connected to the device. As soon as one of
the four sensors has contact with water, an acoustic alarm signal sounds and the activated
loop can be identified by four LEDs. At the same time, a potential-free relay is switched on.
That enables the connection to a BUS system (EIB), or to external devices:
► Signal light (Item no.: 200894)
► Alarm horn (Item no.: 200982)
► Telephone dialer (Item no.: 200893)
► Magnetic cut-off valve 3/8 inch (Item no.: 200995)
► Magnetic cut-off valve 1/2 inch (Item no.: 200996)
Two differing output messages can be defined for each sensor input:
► Alarm message with storage function: The alarm stays on and the relay is switched on,
until the message is turned off again by pushing a button.
► Alarm message without storage function: The alarm remains and the relay is switched
on, until the sensor no longer reports water. (For application as a level indicator or
pump control).
► In addition, for every sensor input, the acoustic alarm can be turned on and off.
Further, the device can be equipped with a 9 V block battery, and can also set off a warning
– even in case of a power failure.
Additional equipment: Relay plug-in card (Item no.: 300747):
There are four potential-free relays on the plug-in card, and thus there are four independent
control circuits available. For every sensor input a relay is assigned.

5. TECHNICAL SPECIFICATIONS

Operating voltage:
Power consumption:
Sensor connection:
Cable length of sensor:
Relay contact:
Acoustic pressure sounder:
Operating temperature:
Protection type:
Dimensions (HxWxD):
Battery (optional):
10
230 V AC / 50-60 Hz
approx. 4 W
up to 4 water sensors
up to 50 m (max)
8 A / 230 V (potential-free two-way contact)
90 dB @10 cm
-15°C / +40°C
IP 20
80x160x55 mm
9 V battery