Alto Professional TS312S Guía De Usuario página 7

Operation
DSP Output Mode
For precise signal adjustment, Alto Professional TS3 subwoofers employ Digital Signal
Processing (DSP). This feature gives you a cleaner, more accurate sound. The DSP controls
EQ, distortion detection/limiting, crossover frequency and signal delay with virtual perfection—
and without the production variability inherent in analog filtering. Simply stated, DSP takes an
analog signal, converts it to digital and then performs all the desired modifications and
adjustments in the digital realm, where it's totally free from the inaccuracies and susceptibility
to added noise that plague analog signal processing. DSP is a major reason why Alto
Professional subwoofers are so clean, dynamic and versatile.
The DSP Output Mode switch on the rear panel of your
subwoofer toggles between six settings that adjust
delay, crossover frequency and the level of the XLR
outputs. This feature optimizes your speaker system
performance while also simplifying your full-range
speaker + subwoofer setup. If you have an Alto
Professional TS3 loudspeaker, using the correct setting
will allow your loudspeaker and TS3 subwoofer to be
time-aligned, crossed over at the ideal frequency and
level-matched.
Press the DSP Output Mode switch to select between the following settings:
•
TS308: Matches your TS3 subwoofer with the Alto Professional TS308 full-range speaker.
•
TS310: Matches your TS3 subwoofer with the Alto Professional TS310 full-range speaker.
•
TS312: Matches your TS3 subwoofer with the Alto Professional TS312 full-range speaker.
•
TS315: Matches your TS3 subwoofer with the Alto Professional TS315 full-range speaker.
•
High Pass: Employs a 100Hz crossover frequency with no delay or level adjustments. This
setting works quite well with a wide variety of non-Alto Professional speakers.
•
Bypass: Bypasses the DSP functions (there will be no crossover, delay or level
adjustments). This setting is ideal for daisy chaining subwoofers.
Once you have selected a setting, the corresponding LED will be lit.
Please Note:
•
For the TS308, TS310, TS312 and TS315 options, the system is level-matched when the
Volume control for TS3 subwoofer and TS3 full-range speaker are set to 0dB (12 o'clock).
This simplifies your setup and elevates the overall system performance.
•
If you do not have Alto Professional TS3 full-range speakers, you can still use the first four
DSP settings for your existing speakers. Cycle through the six options to find the best
sound and then make any level adjustments that are needed.
7