EURO-PRO F1052 Manual Del Usuario página 3

OPERATING INSTRUCTIONS
Using for the First Time
Warning:
Never plug in the control
panel when it is not installed in the fryer
body with heating element in the oil
container. Do not immerse the control
panel, cord or plug in water.
Warning:
This unit should not be used
to boil water
Prior To First Use, Clean The Unit
Thoroughly
Warning:
Always let the fryer cool
completely for 2 hours before taking it
apart for cleaning. Never carry or move
the deep fryer with hot oil inside. Before
cleaning, always make sure the plug is
not in the wall socket.
• All components with the exception of
the electrical parts, can be washed in
warm soap water. Dry thoroughly
before use.
• Use basket handle to remove the frying
basket. Always make sure the basket
handle is securely attached to the
basket. To attach the handle to the
frying basket, insert the metal part of
the handle inside the metal bracket on
the frying basket. (Fig. 1)
• Lift the control panel with heating
element out of its slots by pushing it up
from the bottom with one hand while
holding the body of the deep fryer with
your other hand.
• Remove the oil container.
• Clean the oil container and the frying
basket with hot water, dishwashing
liquid or other non-poisonous detergent
and non-abrasive sponge.
Press together
here
Fig. 1
Warning:
Never immerse the control
panel in water or any other liquids.
Warning:
All components must be
completely dry before filling with oil or
using. Special care must be taken to
ensure the washable oil filter in the lid is
completely dry, otherwise the filter will
not function properly and may lead to
steam being trapped within the fryer
during use.
Warning:
Never exceed the "MAX" line
when filling the basket with food.
Filling the Oil Reservoir
Warning:
Never plug in the deep
fryer before filling with oil to specified
level. Always make sure control panel
is securely in place in the body and the
heating element is inside the oil in the
container before plugging in.
• Use blended vegetable oil, peanut oil,
pure corn oil or canola (rapeseed) oil.
Do not use olive oil, margarine, lard
or drippings.
• The oil level must always be
maintained between the minimum
and the maximum levels marked
inside the oil container. Check the oil
level before each use. For best
results, keep the oil close to the
maximum level (8 cups / 2 liters).
(Fig. 2)
• Never mix different oils and fats
together. Do not mix old and new oil.
Oil level
indicator
Fig. 2
3
OPERATING INSTRUCTIONS
Using Solid Fat
Warning:
Do not put solid shortening in
the oil container or the frying basket.
• If using solid vegetable shortening, melt
it first in a separate pan and then very
carefully pour the melted fat into the oil
container.
• Previously used solid vegetable
shortening which has curdled and
hardened in the oil container should be
removed from the oil container and
melted in a separate pan before
reusing.
Warning:
If you try to melt the solidified
fat in the oil container, there is a risk of
warm melted fat suddenly sputtering from
below through the still solid top layer of
fat. Therefore use only the following
procedure:
• Make sure the fat is at room
temperature. If the fat is very cold,
there is a greater risk of splashing.
• Using a fork, carefully make some holes
in the fat. Make sure the lid is securely
closed while the fat is melting. Press
the temperature select button two (2)
times to select the second temperature
setting of 325° F. The unit will
display "_ _" to indicate a constant boil.
Press power button to turn unit off when
fat has melted.
Installing the "Control Panel With
the Heating Element" Into its Place
• Lift up the control panel with heating
element.
• Insert the "guide edges" on the control
panel (Fig. 3) into the "guide rails"
mounted on the metal body. (Fig. 4)
• Slide the "guide edges" down till the
end.
Important Notice : The automatic safety
switch ensures that the unit will not operate
unless the control panel has been inserted
into the "guide rails" on the metal body
correctly.
Control Panel
Guide
Edges
Safety
Switch
Heating
Fig. 3
Element
Back of Metal Body
Guide Rails
Fig. 4
Using the Electronic Deep Fryer
Warning:
Never plug in the deep fryer
before filling with oil to specified level.
Always make sure control panel is
securely in place in the body and the
heating element is inside the oil in the
container before plugging in.
Important:
Ensure the control panel is
fitted correctly to the main unit otherwise
the unit will not function. This is not a
defect. This product is fitted with a safety
switch to prevent the unit from turning on
accidentally.
4