Correct operate and maintenance
1. A 10A safety fuse should be installed on the power supply code, and use a single grounded socket.
2. Don't extent the power code or add other electrical load.
3. Operate the appliance emptily at the first time, turn the temperature knob to "1-4", then the compressor
start operating. Keep operating 30 minutes, put hands both onto the outside and inside.
If hot outside and cool inside, that means the appliance work normally.
4.During operation, turn the temperature to mid position. Turn it to the highest position while
need freeze.
5.Try not to open the door too often.
to avoid frost cracking or blasting.
6. Do not store flammable, highly volatile and eroded goods.
7. Disconnect the power bar before cleaning the appliance. Use soft cloth to wipe with
warm water or neuter cleaning agent, and then clean it with water.
8. Keep the door gasket clean, on order to maintain well seal.
9. Use soft cloth or soft brush to clean the dust on the compressor and suction tube.
Don't wash it by water.
10. Do not use flammable or strong corrosive cleaning agent to clean the appliance.
Addition: Do not wash it by water directly, in order to prevent rust or reduce insulation of the appliance.