Driving Treads - ECOVACS ROBOTICS W850 Manual De Instrucciones

4. Maintenance
Edge Detection Sensors
Turn WINBOT 8 over and wipe the four Edge
Detection Sensors clean with the provided
Finishing Cloth to maintain their effectiveness.

4.3 Driving Treads

Turn WINBOT 8 over and move the Power
Switch to " " position. Press and hold the
button for 5 seconds to stop the Fan.
Move the Power Switch to the "O" position.
16
EN
Squeegees
Turn WINBOT 8 over and wipe the two
Squeegees with the provided Finishing Cloth to
maintain their effectiveness.
Inspect the Driving Treads by using the
buttons on the Remote Control. Stop the
Driving Treads if dirt is seen on the Treads.
Clean any dirt on the Driving Treads with the
provided Finishing Cloth.
and