Blackstar Amplification SILVERLINE Serie Manual Del Propietário página 9

Recalling Patches
Press any Channel switch to load that patch.
Pressing the Bank switch will cycle through the three banks – green-orange-red.
The Channel will be preserved, therefore the corresponding patch within the current
Bank will be loaded when scrolling through the Banks.
Alternatively, patches can be recalled via Blackstar's INSIDER software or any
connected footcontroller.
Factory Patches Table
Green Bank - Live Rig 1
Channel Patch Name Voice
CH1 LR1 - Clean Clean Warm
CH2 LR1 - Crunch Crunch
CH3 LR1- Rhythm Super Crunch
CH4 LR1 - Lead OD 1
Orange Bank - Live Rig 2
Channel Patch Name Voice
CH1 LR2 - Clean Clean Warm
CH2 LR2 - Crunch Clean Bright
CH3 LR2- Rhythm OD 1
CH4 LR2 - Lead Super Crunch
Red Bank - Live Rig 3
Channel Patch Name Voice
CH1 LR3 - Clean Clean Bright
CH2 LR3 - Crunch Crunch
CH3 LR3- Rhythm Super Crunch
CH4 LR3 - Lead OD 2
16
Response Effect(s) Description
6L6 Spring Reverb US clean with
headroom, perfect as a
platform for your pedals
EL34 Hall Reverb British low gain crunch with
natural reverb
EL34 Tape Delay, Hall British classic rock crunch,
Reverb ideal for guitars
humbuckers
KT88 Analogue Delay Full sounding dynamic lead
Response Effect(s) Description
6V6 Plate Reverb US low wattage 'sag' clean
tone with natural reverb
KT66 Hall Reverb Rhythm tone with breakup,
great for a classic Indie
sound
EL84 Hall Reverb Smooth drive with a slight
mid boost
6L6 Analogue Delay, Balanced lead tone with
Hall Reverb delay, perfect for solos
Response Effect(s) Description
KT88 Flanger, Modulated clean tone,
Analogue Delay, ideal for arppegiated
Hall Reverb chords
EL84 Plate Reverb Dynamic crunch, perfect
for big open chords
6V6 Analogue Delay, Compressed crunch, great
Plate Reverb for rhythm playing
KT88 Analogue Delay, Smooth high gain tone,
Hall Reverb ideal for legato whilst
maintaining note definition
MIDI
Silverline Deluxe and Stereo Deluxe amplifiers are able to recall patches via MIDI
Program Change messages and to dynamically modify amplifier values via MIDI
Control Change messages.
To set-up MIDI control, simply connect your MIDI controller's MIDI Out socket (30)
to the MIDI In socket on the rear of the amplifier.
From new, or after a Factory Reset, the amplifier is set to OMNI mode and responds
to MIDI messages on all MIDI channels.
NOTE: You may wish to set the amplifier to respond to MIDI messages on just a
single MIDI channel. This can be done using the Blackstar INSIDER software to
specify which of the 16 MIDI channels to use, or to return the amplifier to OMNI
mode.
high
Recalling Patches
To recall a patch, the MIDI controller should be set to transmit Program Change
messages (this is usually the case for footcontrollers). Changing patches on the MIDI
controller will activate the corresponding patch stored within the amplifier.
with
Modifying Patch Values
Many patch values (e.g. Gain, Volume, ISF – see MIDI Implementation Chart on
page 100) can be adjusted via MIDI Control Change messages in real-time. The
MIDI controller should be set to send the Control Change messages as defined in
the MIDI Implementation Chart.
17