Ø CLEANING YOUR APPLIANCE
·
Turn off the power, unplug the appliance, and remove all items including shelves.
·
Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
·
Wash the shelves with a mild detergent solution.
·
Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
·
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth.
·
Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.
Ø POWER FAILURE
·
Most power failures are corrected within a few hours and should not affect the temperature of
your appliance if you minimize the number of times the door is opened. If the power is going to be
off for a longer period of time, you need to take the proper steps to protect your contents.
Ø MOVING YOUR APPLIANCE
·
Remove all items.
·
Securely tape down all loose items (shelves) inside your appliance.
·
Tape the door shut.
·
Be sure the appliance stays secure in the upright position during transportation. Also protect
outside of appliance with a blanket, or similar item.
Ø ENERGY SAVING TIPS
·
The appliance should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.
Ø CHARCOAL FILTRATION SYSTEM
Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality
and taste of your fine wines, they must be stored at the ideal temperature and ambient
conditions.Your cellar is equipped with an active charcoal filtration system to ensure air purity, cooling
efficiency, and to maintain an odor free cabinet for the storage of your fine wines. The filter assembly
is located at the rear panel inside your cellar.
Keep in mind, that this filter must be changed every 12 months.
To replace your filter:
1
Remove the bottles / cans stored on the two (2)
shelves in front of the filter.
2
Remove the shelves and set aside to be replaced
once you have changed the filter
3
Hold the filter and turn it at 90 degrees in the anti-
clockwise direction and then pull it out.
4
Remove the existing filter and replace with a new
one.
5
Put the new filter into the hole and then turn the filter
at 90 degrees in clockwise direction..
CARE AND MAINTENANCE
15