Care And Maintenance - Avanti WBC16Z1B-IS Manual De Instrucciones

Enfriador de vinos / bebidas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ø CLEANING YOUR APPLIANCE
Turn off the power, unplug the appliance, and remove all items including shelves.
Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
Wash the shelves with a mild detergent solution.
Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth.
Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur.
Ø POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of
your appliance if you minimize the number of times the door is opened. If the power is going to be
off for a longer period of time, you need to take the proper steps to protect your contents.
Ø MOVING YOUR APPLIANCE
Remove all items.
Securely tape down all loose items (shelves) inside your appliance.
Tape the door shut.
Be sure the appliance stays secure in the upright position during transportation. Also protect
outside of appliance with a blanket, or similar item.
Ø ENERGY SAVING TIPS
The appliance should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.
Ø HIGH AND LOW TEMPERATURE PROTECTION SYSTEMS
This appliance is equipped with a HIGH and LOW temperature protection system:
HIGH Temperature:
Display Code:
HH
After the first hour of use, if the system detects temperatures above 78ºF continuously for
approximately 20 minutes, the system will activate the protection system, display HH in the display
window and a buzzing noise will be heard for 20 minutes. The system will run the compressor for
5 minutes and shut off for 10 minutes to stabilize the temperature. Once the system returns to
normal temperature (below 78ºF), the HH display and buzzer will turn off.
LOW Temperature:
Display Code:
LL
After the first hour of use, if the system detects temperatures below 5ºF continuously for
approximately 20 minutes, the system will activate the protection system, display LL in the display
window and a buzzing noise will be heard for 20 minutes. The system will shutdown the
compressor until the interior temperature reaches a minimum of 36ºF, once the minimum
temperature has been reached the LL display and buzzer will turn off.

CARE AND MAINTENANCE

10

Publicidad

Tabla de contenido
loading

Tabla de contenido