Step 6 - Nozzle And Skimmer Installation - Trigano PISCINES ABAK OSMOSE Serie Instrucciones De Montaje

Do not stretch the liner excessively. To do so, your feet must bring the bottom of the liner towards the base of the wall (JJ). Proceed the same
way on the opposite side.
This allows you to check whether your liner is centred. There must not be any crosswise creases.
To ll your pool, do not use reclaimed water (well, river...).
Start lling the pool with 1 or 2 cm of water. Spread the liner out on the bottom and remove any wrinkles by sliding them with the at of
your hand from the centre of the pool towards the edge, until they are completely gone.
As soon as your liner is in place, you may proceed with installing the plastic sections (810 041) around the upper perimeter.
Cut the excess from the last plastic section (810 041). Install the upper rails (EE) which must be vertical to the lower rails
(DD) and bring down the connecting plates (820 121) on the rails (EE) without attaching them.
Up to 20 cm of water, you must remain near or in the pool. At this stage, if the liner is correctly tensioned, you may de nitively attach the
connecting plates (820 121) by tightening the attachment screws.
Provide cut-outs in the liner for installing the skimmer and the discharge nozzle before completely lling your pool (see Step 6).
810 041
Liner
Wall
Step 6 : Nozzle and Skimmer Installation
WARNING
All threaded nipples should be attached with Te on, wound in the
opposite direction of the thread;
Seek advice from the manufacturer for any modi cations to one or
more ltration system elements.
WARNING
A – Discharge Nozzle Installation
When assembling a pool with a ltration system through the wall (JJ), the
following operations must be performed:
As you are lling, when the pool water level is within 5 or 6 cm from the
discharge nozzle, make a cut in the liner in the shape of a cross using a
cutter without exceeding the hole (Figure 3) and fold the cut edges over
the wall (JJ).
EE
Raise
Flip
All ltration systems comply with installation standard NF C 15-100 stipulating that all electrical
devices located within 3.50 m of the pool and freely accessible must be powered by very low voltage
(12 V). Any device powered with 220 V must be located at least 3.50 m from the edge of the pool.
This means that:
for a sand lter, the device must be installed more than 3.50 m from the pool,
for a ltering skimmer, the transformer must be more than 3.50 m from the pool.
Never de nitively install the skimmer or the discharge nozzle before the water comes within a
few centimetres from the parts to be installed since the liner must be tightened by the water
pressure.
Fold over
121 305
Liner
Wall
Figure 2
Figure 3
66 Notice N°880101 Rev B
Discharge nozzle
Skimmer
10