Descargar Imprimir esta página

Avanti WDB20Y0W Manual De Instrucciones página 4

Soporte para secadora de ropa

Publicidad

Idiomas disponibles

Idiomas disponibles

Your Washer / Dryer Stacking Rack is designed to accommodate both top loading or front loading
washing machines. Follow the assembly instructions below to assemble the Rack to fit your specific
washing machine type. Images shown in this instruction guide are for assembly for use with a TOP-Load
Step 1:
Assembling the legs:
When using with a TOP- Load washer.
·
Assemble the rear legs by screwing together all two sections of the
rear leg.
Part D – Rear Leg (Bottom section)
Part E –Rear Leg (Top section)
·
Assemble the front legs by screwing together all two sections of the
front leg.
Part F – Front Leg (Bottom section)
Part P – Front Leg (Top section)
Step 2: Assembling the Bottom Support Frame.
We suggest that you put the U shaped bottom support frame
(Part A) in a vertical position. As this will allow you to insert
the legs and the Shelf / Frame support clips with ease.
a) Lay the Bottom support frame (Part A) on its back with
each side bar facing upwards.
b) Insert each of the rear legs (assembled in step one)
into the holes at both rear corners of the support
frame.
c) Using the Shelf / Frame support clips (Part I) insert
the plastic tapered clips into the appropriate grooves
on each leg. (See the image).
d) Slightly press the bottom support frame downward on
to the support clips.
e) Insert each of the FRONT legs in the remaining corner
holes of the support frame and repeat Step C.
f) Stand the unit upright to continue the remainder of
this assembly.
g) Press each corner downward firmly to ensure the
support frame is fully locked into position.
washer.
4

Publicidad

loading