Installation; Preparing The Housing Unit; Electrical Connection - Whirlpool AKP 738 Manual De Instrucciones

Installation

Excessive Weight Hazard
Use two or more people to move and
install the appliance.
Use two or more people to move and
install the appliance.
After unpacking the oven, be sure that it
has not been damaged during transport
and that the oven door closes properly.
In the event of problems, contact the dealer
or your nearest after-sales service.
To avoid damage, remove the oven from
its polystyrene foam base at the time of
installation only.

Preparing the housing unit

• Kitchen units in contact with the oven
must be heat resistant (min 90 °C).
• Carry out all cabinet cutting work before
fitting the oven into the housing and
carefully remove all wood chips and
sawdust.
• After installation, the bottom of the oven
must no longer be accessible.
• For correct appliance operation, do not
obstruct the minimum gap between the
worktop and the upper edge of the oven.

Electrical connection

Fire Hazard
The installation of this product
requires a proper electrical
dimensioning.
Install the product in accordance
with the instruction manual.
Failure to do so can result in death,
explosion, or fire.
Be sure the power voltage specified on
the appliance dataplate is the same as
the mains voltage.
The dataplate is on the front edge of the
oven (visible when the door is open).
• If the power supply cord is damaged,
it must be replaced by an authorized
service center to prevent accidents
from happening.
45