Safety Instructions - Belle Group MINIMIX 140 Manual Del Operador

Before starting the mixer
Ensure engine oil is fi lled to correct level before operating mixer. Note: The engine must be lifted to the horizontal position when
fi lling and checking oil.
Check that all guards are in position and correctly fi tted.
DO NOT wear loose clothing or jewellery that may become entangled in the workings of this machine.
Suitable clothing as follows should meet relevant EEC/local safety standards: overalls, work boots, goggles, face mask, gloves
and ear defenders etc.
DO NOT tip mixer onto the drum mouth when motor is running.
Ensure that any trailing cable is protected against damage and not liable to be tripped over or trapped underneath the mixer.
We recommend the use of an Residual Current Device on 230v electrics.
Remove all packaging material before operating.
When operating the mixer
Keep unauthorised persons away from mixing drum.
Keep area around the mixer clear of obstructions which could cause persons to fall onto moving parts.
Always ensure mixer is on level ground before mixing.
DO become familiar with the controls before operating this machine.
DO ensure that all guards are fi tted in the correct position.
DO ensure plenty of ventilation when running diesel/petrol engines in a confi ned area.
DO replace any worn/damaged warning decals.
DO ensure the drum is rotating while emptying the mixer.
DO always switch off and remove the plug from the socket if leaving the machine unattended.
DO NOT use as a wheel barrow. Disconnect from power supply before moving.
BEWARE of the Danger Zones & Hot Zones.
BE AWARE of exhaust venting directions.
Emergency Stop
If you have to turn off the mixer in a emergency you must: Electric: either turn off at switch or at the mains, Petrol: turn the engine
switch off, see engine manual.
Fire Fighting
If your mixer catches fi re, turn off the electric supply. Using a dry powder or C02 fi re extinguisher put out the fi re. If the fi re can not be
put out, keep away and call the fi re brigade. If you are in any doubt about the safety condition of your machine, please contact your
Belle authorized Service Dealer.
Warning - Important
Should the socket outlets in your home not be suitable for the plug supplied with your product, the plug must be removed (cut-off if it
is a moulded plug and disposed of) and an appropriate plug fi tted. Follow wiring instructions carefully. Do not connect either core to
the earth pin, as this is a Class II Isolated Product.
BLUE = NEUTRAL & BROWN = LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured Blue must be connected to the terminal which is is marked with the letter N or coloured Black. The wire
which is coloured Brown must be connected to the terminal which is is marked with the letter L or coloured Red.

Safety Instructions

6
GB