Dust Extraction - PORTAMIX Mega Hippo Instrucciones De Uso

FOR WET PRE-MIXED PRODUCTS
1. Pour product to be mixed or blended
into mixing canister
2. Ensure that the mixing helix is totally
covered. It may be necessary to select
a mixing shaft with a shorter helix to mix
a small batch, or a larger helix to mix a full
batch. This will ensure thorough mixing.
3. Pour product to be mixed or blended
into mixing canister
CANISTER REMOVAL
The canister may be removed from the cradle by
undoing the pin bolt and lifting the canister out.
LINER OPTION
The Mega Hippo has a canister option, PH704,
which allows the use of a liner. This liner can be used
for mixing all the products that the Mega Hippo is
designed to mix. The liner is particularly designed
for mixing very abrasive materials or resins and

DUST EXTRACTION

The Mega Hippo canisters and liners are supplied with
a dust extraction port for attaching a dust extraction
hose. The dust port will fit a standard 50mm diameter
taper hose cuff.
08
DANGER—SAFETY: Keep hands and other objects well clear of the mixing shaft and canister when mixer is in operation or serious injury could result.
4. Select the best speed according to material being
mixed. Turn mixer on.
5. When mixing is complete, unplug power supply
from motor unit.
6. To dispense mixed material, release the tilt lock
by pushing the tilt lock lever down, and tilt the
canister cradle. Hold the cradle handle firmly
to ensure a controlled pour.
epoxy materials that require solvent based cleaning
products. To fit or remove the liner, remove the motor
mount from the mixer, complete with the motor and
helix. Lift out or install the liner into the canister.