Port: 2202
The following messages can be used to communicate with an AMX or Crestron unit across an Ethernet connection.
Message Types
The control system sends the following command messages:
Sent from the control system to the Shure device to change the value of a parameter. Used to set the para
SET
meter to a specific value. Once a SET command is sent, the Shure device sends back a REPORT string
with the current resultant setting.
Gets the current value of a parameter. Once a GET command is sent, the Shure device will send back a
GET
REPORT string with the current setting.
Reports the current value for a parameter. The REPORT string is sent from the Shure device to the Control
REPORT
system in response to a SET or GET command. The REPORT string is also sent when the value of the pa
rameter is changed on the Shure device.
Syntax
All messages sent and received are ASCII characters.
•
Each message begins with a "<" followed by a space.
•
Each message ends with a space followed by an ">"
•
Each message is terminated by a carriage return and line feed (CRLF). The control system may need to enter the hex va
lue, equivalent to 0x0D0A. Please see the control system user guide for information on entering carriage returns.
•
If the message is a box parameter, there should be no channel number in the string.
Example Messages
Example Messages for Channel Parameters
•
< GET 1 FREQUENCY >
•
< REPORT 1 FREQUENCY 578000 >
Example Messages for Box Parameters
•
< SET DEVICE_NAME Shure >
•
< REPORT DEVICE_NAME Shure >
Tabla de respuesta a comandos
Ver el nombre del transmisor
Asignar nombre al canal
Obtener el nombre del canal
Ajustar el nivel de audio
Ver el nivel de audio
RESPUESTA
GET DEVICE_NAME
SET x CHAN NAME vvvvvvvv
GET x CHAN NAME
SET x AUDIO_IN_LVL vvvv
GET x AUDIO_IN_LVL
COMANDO
REPORT DEVICE_NAME vvvvvvvv
REPORT x CHAN_NAME vvvvvvvv
REPORT CHAN_NAME vvvvvvvv
REPORT x AUDIO_IN_LVL vvvv
REPORT x AUDIO_IN_LVL vvvv
Shure Incorporated
33/42