Danby DWM030WDB-6 Manual Del Propietário página 6

INSTALLATION INSTRUCTIONS
Connecting the quick connect to the water supply
Remove the aerator from the faucet before attaching
the faucet adapter.
Pull down on the locking collar and pull up on the
faucet adapter to remove the adapter from the
assembly and then install the adapter on the faucet.
Turn on the faucet to check for leaks at the
connection before continuing. If leaks are present,
it may be necessary to wrap the faucet adapter or
the faucet with Tefl on tape before connecting the
adapter to the faucet.
Pull down on the locking collar and push the quick
connect assembly onto the bottom of the faucet
adapter. Release the locking collar to attach the
quick connect to the faucet.
Attach one end of the water inlet hose to the quick
connect assembly. Place the other end of the hose
in the sink and turn on the water supply to clear the
hose of any dust. When the water runs clear, turn
off the water supply and connect the hose to the
water inlet connection on the top of the appliance.
DRAIN HOSE INSTALLATION
The drain hose will arrive pre-attached to the
appliance. During operation of the appliance, the
drain hose should be directed toward a sink or
drain to catch the discarded water as it exits the
appliance.
When running the drain hose to a drain, ensure that
there are no bends in the hose as this can cause a
blockage and impede the drain function.
The drain hose can be directed upward toward a
sink or bucket but ensure that the hose does not rise
more than 100 cm (39 in) from the ground as this
can impact the drain function.
5