Danby DUF071A3WDB Manual Del Propietário página 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove both leveling legs from the appliance.
2. Remove the screws securing the lower hinge
assembly on the right side of the appliance.
3. Move the lower hinge pin from the front of the
hinge assembly to the back.
4. Remove the door from the appliance.
5. Remove the hinge pin from the top right side of
the worktop and the hole cover from the top left
of the door and swap their positions.
6. Remove the hole cover from the bottom left of
the door and place it in the hole on the bottom
right side of the door.
7. Reinstall the door on the appliance. Ensure the
top of the door is properly aligned with the top
of the cabinet and that the rubber gasket makes
a good seal with the cabinet all the way around.
8. Reinstall the lower hinge on the left side of the
door. It will need to be fl ipped 180° from its
original position to ensure that the hinge pin
enters the hinge hole on the bottom left side of
the door.
9. Reinstall both leveling legs and ensure that the
appliance is level.
5