Danby DKC054A1BSLDB Manual Del Propietário página 8

INSTALLATION INSTRUCTIONS
INSTALLATION OF CO
Install the metal support onto the four studs located
on the exterior back wall of the cabinet.
Align the holes in the support with the studs and
push down fi rmly.
INSTALLATION OF CO
The CO tank does not come fi lled. The tank must be
2
fi lled with CO before use.
2
Place the charged tank into the support stand.
Attach the CO regulator to the tank by turning
2
the regulator nut onto the tank valve, making sure
the washer is securely inserted into the connecting
nut. Tighten snug using an adjustable wrench (not
supplied) and ensure there are no leaks, i.e. no
hissing sounds when the CO
INSTALLATION OF CO
Remove the plug located at the exterior back of
the cabinet, in the top left hand corner. Save the
plug for later use to convert the appliance to a
refrigerator.
Feed the gas line through the cabinet and out
through the uncovered hole.
Attach the open end of the hose to the hose barb
connection on the regulator. Secure the hose
by using one clamp provided. Use pliers or a
screwdriver to tighten the clamp to prevent leaks
TANK SUPPORT
2
TANK AND CO REGULATOR
2 2
is turned on.
2
AIR LINE AND CONNECTION TO CO
2
.
REGULATOR
2
7