Subsequent Startups - Ducati Energia REGO 5 Manual De Instrucciones

NOTE: FOR A CORRECT WORKING OF THE CONTROLLER,
CHECK THAT POWERS MEASURED BY THE CONTROLLER ARE
CORRECT.
If the power measurements are correct, the user can press the
DATA key for three seconds to exit this menu and the controller
will start to work automatically, displaying the letters "COS" in turn
with the system power factor.
Ex.

8) SUBSEQUENT STARTUPS

As soon as the controller is switched on, 8.8.8. will appear on the
display for a few seconds and all the LEDs will light up to enable their
efficiency to be checked.
Subsequently the controller will alter nately display "FAS"
and "0" or "1";
Ex.
at this stage the system will read and display the direction of the
incoming current from the C.T. (0 = direct / 1= inverted). It is only an
indication.
NOTE: if the incoming current is insufficient (less than 200mA), REGO
cannot determine its direction and will stand by in this status until
current is supplied.
64