Final Assembly - Heath Zenith 5835 Manual De Uso

WARNING: Turn power off at circuit breaker or fuse.
Place tape over circuit breaker switch and verify power is
off at the fixture.
This fixture comes with a "Easy Install" mounting plate. It is pre-
assembled on the fixture for shipping.
1. From the front of the light fixture, unscrew the large mounting
bolt connecting the light fixture to the mounting plate and remove
the mounting plate (see Figure 1). The mounting bolt is designed
to stay in the light fixture.
2. Install the mounting bracket with the stamped word "FRONT"
facing away from the junction box (see Figure 2). Use the mount-
ing bracket screws that best fit the junction box.
3. Route the junction box wires through the hole in the mounting
plate (see Figure 3).
4. Place the mounting plate against the junction box (see Figure 3).
• Wall Mounted – The "UP" arrow must point upward
• Eave Mounted – The "UP" arrow must point toward the building
5. Insert the small mounting bolt through the mounting plate hole
located below the threaded hole. Thread the bolt into the center
hole of the mounting bracket (see Figure 3). Tighten bolt securely.
Insert the junction box wires into the side of the terminal block and
around the ground screw (see Figure 4). Tighten terminal block screws
and ground screw to secure wires.
• White to "N (White)"
• Black to "L (Black)"
• Bare or green ground wire to GND (ground) screw.

FINAL ASSEMBLY

1. Double check that all wiring connections are securely connected.
2. Align the two alignment posts on the mounting plate (see Figure
3) with the two alignment holes on the rear of the light fixture
and press the light fixture onto the mounting plate.
IMPORTANT: The two metal pins on the rear of the light fixture
must insert into the terminal block for the light to work.
3. Tighten the mounting bolt securely being careful not to overtighten
(see Figure 5).
209735-01
INSTALLATION
WIRING
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 1
T
O N
F R
T
O N
F R
Figure 2
Figure 3
UP/Haut/Arriba
GND
Terre
Tierra
Figure 4
T
N
O
R
F
Alignment
Post
N (White/
Blanc/Blanco)
L (Black/
Noir/Negro)
3