NOTE:
We do not recommend
sharpening
blade - but if you do, be sure the blade is
balanced..
TO SHARPEN
BLADE
Care should be taken to keep the blade
balanced. An unbalanced blade will cause
eventual damage to lawn mower or engine.
o The blade can be sharpened with a file or
on a grinding wheel. Do not attempt to
sharpen while on the mower.
° To check blade balance, drive a nail into a
beam or wall. Leave about one inch of the
straight nail exposed. Place center hole of
blade over the head of the nail If blade is
balanced, it should remain in a horizontal
position. If either end of the blade moves
downward, sharpen the heaw end until the
blade is balanced.
GRASS CATCHER
- The grass catcher may be hosed with
water, but must be dr/when used.
• Check your grass catcher often for damage
or deterioration. Through normal use it will
wear. If catcher needs replacing, replace
only with a manufacturer approved
replacement catcher. Give the lawn mower
model number when ordering..
Blade
Crank shaft
adaptor
Bolt
Crank
Lockwasher
Hardened
Blade
shaft
washer
Trailing
adaptor
edge
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification SF, SH or
SG. Select the oil's SAE viscosity grade
according to your expected operating
temperature°
r____
o.AoE
_j
1
!
t
.....
"C .,30"
.20"
*la _
.........6"..............10"
20"
,_¢f
I"EMPE_RE
RANGE ANTtC|PATEO BEFORE NEXT OIL CHAN
NOTE: Although multi--viscosity
oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi--viscosity
oils
will result in increased oil consumption
when used above 32°F. Check your
engine oil level more frequently to avoid
possible engine damage from running tow
on oil.
Change the oil after every 25 hours of opera-
tion or at least once a year if the lawn mower
is not used for 25 hoursin one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE
ENGINE
OiL
NOTE:
Before tipping
lawn mower to drain
oil, drain fuel tank by running
engine
until
fuel tank is empty.
° Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come in contact with spark plug.
. Remove
engine oil cap; lay aside on a
clean surface°
o Tip lawn mower on its side and drain oil
into a suitable
container_
Rock lawn
mower back and forth to remove
any oil
trapped
inside of engine,
o Wipe off any spilled
oil on lawn mower
and on side of engine.
° Fill engine with oil. Fill only to the "FULL"
line on the dipstick.
DO NOT OVER
FILL
° Replace
engine
oil cap.
= Reconnect
spark plug wire to spark
plug.
Container
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air filter.
Replace the air filter every year, more
often if you mow in very dusty, dirty
conditions. Do not wash air filter.
TO CHANGE AIR FILTER
o Remove the air filter cover by turning
counterclockwise
to the stop and pull
away from collar.
• Remove filter from inside of cover.
12