Important Information
Equipment Approval Information
Your telephone equipment is approved for connection to the
Public Switched Telephone Network and is in compliance with
parts 15 and 68, FCC Rules and Regulations and the Technical
Requirements for Telephone Terminal Equipment published by
ACTA.
1 Notification to the Local Telephone Company
On the bottom of this equipment is a label indicating, among
other information, the US number and Ringer Equivalence
Number (REN) for the equipment. You must, upon request,
provide this information to your telephone company.
The REN is useful in determining the number of devices you
may connect to your telephone line and still have all of
these devices ring when your telephone number is called. In
most (but not all) areas, the sum of the RENs of all devices
connected to one line should not exceed 5. To be certain
of the number of devices you may connect to your line
as determined by the REN, you should contact your local
telephone company.
A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply with
the applicable FCC Part 68 rules and requirements adopted
by the ACTA. A compliant telephone cord and modular plug
is provided with this product. It is designed to be connected
to a compatible modular jack that is also compliant. See
installation instructions for details.
Notes
• This equipment may not be used on coin service provided
by the telephone company.
• Party lines are subject to state tariffs, and therefore, you
may not be able to use your own telephone equipment if
you are on a party line. Check with your local telephone
company.
• Notice must be given to the telephone company upon
permanent disconnection of your telephone from your line.
• If your home has specially wired alarm equipment
connected to the telephone line, ensure the installation of
this product does not disable your alarm equipment. If you
have questions about what will disable alarm equipment,
consult your telephone company or a qualified installer.
US Number is located on the cabinet bottom
REN number is located on the cabinet bottom