Nstalling The Andset Attery - RCA H5400 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Avoid areas of excessive moisture or extremely low
temperature.
• Avoid dusty locations.
• Avoid other cordless telephones or personal computers.
INSTALLATION NOTE: Certain other communications
devices may also use the 900 MHz frequency for
communication, and, if not properly set, these devices
may interfere with each other and/or your new
telephone. If you are concerned with interference, please
refer to the owner's manual for these devices on how to
properly set channels to avoid interference.
Installing the Handset Battery
NOTE: You must connect the handset battery before use.
CAUTION: To reduce the risk of fire or personal injury,
use only the Thomson Inc. approved Nickel-metal
Hydride (Ni-MH) battery model 5-2650 that is
compatible with this unit.
1. Locate battery and battery door which are packaged
together inside a plastic bag and are separate from the
handset.
2. Locate the battery compartment on the back of the
handset.
3. Plug the battery pack cord into the jack inside the
compartment.
NOTE: To ensure proper battery installation, the connector
is keyed and can be inserted only one way.
PRESS DOWN
FIRM LY
4. Insert the battery pack.
5. Close the battery compartment by pushing the door up
until it snaps into place.
Connections and Setup
BA TTER Y
RED WIRE
BLACK WIRE


Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido