USE CLOCK
To setup the time of the unit
1. connect the ac on(
2.short according to the time button, the time will flashing on the lcd display.
3.
Press
BACK、NEXT to select the number of the time. you can setup the time
format by 12h or 24h.
4. press time button to confirm.
5.then you can set the hour and the minute with the same method of steps 3-4.
6.
after setup the unit time, long press the time button can setup the unit begin working
time ,
with the same method of steps 3-4.
Note: after setup the beginning time, the lcd will display the radio/cd/usb/aux mode,
Press
the BACK or NEXT to choose the mode, then it press time button to affirm,
otherwise it play usb or aux mode first.
USE RADIO
Radio reception
1.
Press
FUNCTION
2.Tune to required station by press BACK or NEXT.
Manual Tuning:
Press
Press the play/pause button enter the automatic channel
Auto Tuning:
scan
Preset Channel:(FM 30 Preset memories)
(1) Press BACK or NEXT Select desired station.
(2) Press PROGRAM button once , The MEMORY number indicator begins steady in
the display.
(3) Press PRESET-UP
(4) Press PROGRAM button to save that station.
(5) Repeat steps (1) to (4) procedures for other stations.
3.After end of program. press PRE-UP or PRE-DN to start play the frequency that you
selected or press number key on the remote control.
Press [VOL-]or [VOL +] to adjust the volume.
4.
5.Extend TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting.
6.Turn off the radio by press FUNCTION button select other mode or press power button
to off the unit.
7.Switch on again after shut down,the memory frequency still exists.
The following operation must be in standby mode)
button
select RADIO
BACK or NEXT and then release within 1 sec.
mode, and to be put automatically sets.
or
PRESET- DOWN buttons to select the desired number.
.
mode
EN-6
.